** syntax error

Discussion in 'Setup & Installation' started by vtpaindoc, Jul 3, 2008.

  1. vtpaindoc

    vtpaindoc New Member

    All was going well until...

    perhaps my DB structure became corrupted. My receptionist thinks she accidently changed a Patient's Birthday (her words). Anyway, now I cannot access the program. The server will startup fine.

    Trying to access via (any) client yields:

    ** syntax error: missing [ at end of block

    ** near: (line 18) ] ] ] ]

    ** press enter to quit...


    Start Edit:

    Just searched and found some similar posts-I'll try those suggested fixes.

    End Edit.
  2. Jason

    Jason Developer / Handyman Staff Member

    reboot the server.

    and if that doesn't work ... go back to an older client.

    The latest betas are really not to be used as Graham has been tinkering too much.

    My secretary had some bugs filing scans today and so I got her back on an earlier beta.

    I went back to April synaspe 214 beta10 I think.

    Synapse is very stable but with the massive changes in the latest betas, little things are going awry. We were getting error messages that are fake .. like ... "this isn't available in this context" ... yet it did it anyway.

  3. vtpaindoc

    vtpaindoc New Member


    This worked...


    Had rebooted everything (including router) multiple times w/o success.

    Life is good again

Share This Page